Call us to get tree helping such as tree remove, tree dig, bush disposal, shrub felling, stump disposal and plenty more around United States.

Click to call

Call +1 (855) 280-15-30

I broche.

Jul 23, The tail housing bolts use a 9/16" wrench as do most of the cross member bolts. The transmission support/mount uses 3/4 wrench to the ones that screw into the tail housing and the drive shaft u-bolts are 1/2" wrench. _____ Larry 96 Ford F PSD CC DRW 97 Ford Taurus 64 Fairlaine rust bucket/future Tbolt clone with BBFEstimated Reading Time: 2 mins.

Replacing the output shaft seal and bushing on a ford c6 transmission from a Ford F with a m. Feb 14, The output shaft in my 65 C4 automatic seems to have excessive play since it wiggles back and forth about 1/4 inch either way.

Due to a sever driveline vibration at 60 mph, I took my driveshaft in for a complete rebuild and a brand new slip yoke. I am thinking that the tailshaft bushing Estimated Reading Time: 5 mins. Feb 05, Discussion Starter #1 Feb 3, I was attempting to replace the rear seal on the 67 C4 today and got the driveshaft out okay.

The trans drips a bit from the output seal when parked uphill.

Ml Minette M.

I failed at my attempt to use the screwdriver/hammer approach to remove the old seal. I stopped because I noticed the output shaft has a lot of play Estimated Reading Time: 2 mins. An extension housing leak sealing kit for a FORD C-4 Transmission, This kit will solve leakage issues at the rear of the transmission. Made in USA. Includes: C-4 Metal Clad Rear Seal for Extension Housing C-4 Extension Housing Bushing C-4 Extension Housing Paper Gasket.

On drink some?

May 09, take the tailshaft housing off,not that bad of a job,take out speedo cable,take trans. mount bolts out,jack up trans.

with 2x4 under pan,take member bolts out and let it hang down,take bolts out of tailshaft and slid 91316 Encino CA off,they do have a tool to remove and a tool to install tailshaft bushing,when you install new bushing the hole in bushing goes to the bottom.